by Roddy | Nov 13, 2018 | User-Guide-Commander
Mediant uses components from “Indy” (www.indyproject.org). Indy’s licensing terms and copyright are shown below. Indy BSD License Copyright Portions of this software are Copyright (c) 1993 – 2003, Chad Z. Hower (Kudzu) and the Indy Pit Crew –...
by Roddy | Nov 13, 2018 | User-Guide-Commander
Network Problems Most problems with Commander-IS are likely to be due to network access of Imagestores. A simple check is to confirm that the Imagestore can be contacted via Ethernet using the ‘ping’ command from the DOS prompt. If this works, you should see something...
by Roddy | Nov 13, 2018 | User-Guide-Commander
When using Commander with Miranda Imagestore 750 units, an additional tab is available. This tab allows you to view the status of all video inputs to the unit, and the status of the reference signals, both internal and external. You can also select which signals are...
by Roddy | Nov 13, 2018 | User-Guide-Commander
Various additional functions are on this page: Log Message inserts the specified message into the Imagestore’s log file. Use this to hold short notes about Imagestore misbehaviour, or changes in the configuration. The log files are typically for the use of Miranda...
by Roddy | Nov 13, 2018 | User-Guide-Commander
Commander-IS can control the IS3’s integral MPEG player directly, allowing clips to be loaded and played without using an Imagestore keying layer. This is particularly useful when the IS3 MPEG video is connected to the B input of the Imagestore, and allows Imagestore...
by Roddy | Nov 13, 2018 | User-Guide-Commander
The controls on this page are for Bugclock timers. Time-of-day clocks are not affected. Timers can be stopped, started and reset, or set to predefined values.